So, even if you see we have a lot of commands other commands available. So let's say if you want to select a particular element you can choose. So now you can see, you can select a particular element. So same way if you see, you can see the coordinates. Now. Now what you're selecting is make make notes.
So, if it is a second order element, then only you can able to select mid side notes. And if you want to create any label, so by using this you can create it and even here also, if you want To select a particular area of measurements, you can use bulk select. So if you want to select single element, you can select the single. And even you can see whole wireframe of mesh if you use this, right, so let's make it normal. And if you go here, mesh matrix so if you click on element quality, so here you can see the quality of elements. So if you click on mess metrics, just click on controls.
Here you can see the properties. So you can see now of data elements which elements so, these are automatically created. So, you can see here mesh graph. So, so this is a mesh graph. So number of bars, here you can see number of elements and percentage volume and stuff. So totally verge and get elements.
So, same way you can change to here you can see the value average standard deviation, minimum and Max, right, the max should be below point one, then only the quality of filament is good Next one is the aspect ratio. So, we don't count any messes. So, now you can see the graph here. So, number of data elements is 10 and which elements, so which are deviated? So, here you can see Max is 13 and the minimum is 10. So, based on the type of quality parameter, so, it is going to be changed the same be Jacobean.
So, these values are not standard for all our mesh parameters, it is going to change based on the parameter we are going to use. So, the next is skewness. So, skewness should be Very, very less. For structurally though it's okay but for CFD, it should be always point 04. So, next one is wrapping factor, this is one more quality parameter. So, this also should be less than point 4.9.
So, this is how we can see the quality of the element and this quality of elements can be changed by changing these parameters, relevance proximity, these are parameters even if you want we can change this, these factors also. So, maximum size and maximum faces all those stuff. But for structural it's Kimber Tobin We are dealing with the CFD, we have to take care of each and every parameter even in the structural also. So, simply by using these parameters, we can execute the maximum quality of the elements