So let's duplicate this first collection. And we can, you know, rename this collapse and inspect. And remember to turn your top layer off. So we don't need the camera and we don't need the light. So let's go ahead and delete those. And let's apply all the modifiers on our 3d photo.

And so we don't need the cube. And we've got our mesh. So let's go ahead and edit this and kind of check it out with our 3d printing toolbox. And we can just do check Oh, and it may take a while because we do have a lot of faces going on here. It would have been 10 times longer if we hadn't have decimated it. But notice we do have we have zero non manifold edges, we have some intersecting faces and zero edges.

So usually what I like to do is just select all and go to mesh cleanup, remove doubles and nothing really have let's bump it up just one. Alright, that took away some so that should help a little bit. Let's check again. And it may take a moment. So yeah, that got rid of ours. faces.

But what I've noticed doing these in my examples is that it's really hard to get it to be kind of perfect. But usually as long as you have zero non manifold edges, then you're probably pretty good. You could even sometimes for these, you could even try the make manifold, and it seems to do something, but at the bottom, it's zero on everything. So I don't really know if it did anything, but maybe it tried, we'll check all it did lower some things. But I think we could go ahead and 3d print this. Let's go ahead and check.

I think it's gonna be fine. So let's rename this. And we can call this lover VR moon. And we could call it draft one. So I can do like D one, since some of these aren't fixed. So just kind of a an test here.

And we can tell Blender where we want to put it hit accept, we'll do an STL and export. You notice we'll get the confirmation down at the bottom and then just open that file in the slicer of your choice. And here we have it Cool 3d printable photo. So for the settings on the litho pane, you want to make sure you have your infill set really high like 200. We don't need rafts we don't need supports. And for the layer, you can do like a point two, and maybe two or three outer shells, whichever you prefer.

And hit OK. So the 3d printer will make a little heavy bottom that is fully plastic, then it'll start making the 3d photograph. Alright, let's go ahead and send it to 3d print.